Upol Easy 1 Body Filler and Hardener 3lt.

Description U-POL Easy 1 Body Filler and Hardener 3lt. Panel Beating, Nikki. An easy to use, smooth textured polyester filler for deep repairs. The non-sag formula is ideal for use on vertical or horizontal repairs and its lightweight formula bonds to multiple substrates including galvanised steel, metal and GRP. Smooth textured, tack free finish Easy spreading and quick to shape Non-sagging when used on vertical surfaces Very smooth and easy to spread making easy application. Non-porous formula will not shrink. Quick drying time promoting efficiency. Typical Use Ideal for filling and shaping medium to deep panel damage Surface Preparation Bare Steel S2001 Fast/S2002 Slow Solvent-Based Degreaser P80 Aluminium S2001 Fast/S2002 Slow Solvent-Based Degreaser P180 Galvanised S2001 Fast/S2002 Slow Solvent-Based Degreaser P180 Original Paint S2001 Fast/S2002 Slow Solvent-Based Degreaser P180 GRPS2000 Water-Based Degreaser P180 EASY 1 LIGHTWEIGHT BODY FILLER FOR DEEP REPAIRS has superb adhesion to all the substrates above. For best results, good preparation is essential. Clean and degrease removing dirt, oil, grease and wax using cleaning solutions such as U-POL’s SYSTEM 20 Degreasers. Abrade with grit paper as stated above for each respective substrate. Re-clean, dry and degrease the abraded substrate ready for application. 10 Degree Celsius  Mixing ratio (BPO Hardener): 3% Gel Time: 6 – 7 minutes  Sandable after: 20 minutes   20 Degree Celsius Mixing ratio (BPO Hardener): 2% Gel Time:4 – 6 minutes  Sandable after: 15 – 20 minutes 30 Degree Celsius Mixing ratio (BPO Hardener): 1% Gel Time: 4 – 5 minutes Sandable after: 15 minutes Maximum Fill Depth 4 – 7 mm Infrared Bake: 50 – 80 cm, 80 °C, 5 minutes Mix thoroughly on an Onion Board Mixing Palette. Follow mix ratio carefully. Do not under or over catalyse. Apply with a pressing action to reduce air entrapment. Not recommended for applications below 5°C Sanding Initial Sanding P80 – P120 Final Sanding P180 – P240 U-POL recommends using Guide Coat Aerosol during the sanding process to identify the high and low spots. A U-POL Finishing Filler such as DOLPHIN GLAZE can be used to fill imperfections such as pin holes and scratches prior to painting